Plinth Builder

Configure a circular or rectangular display plinth, inspect the generated STL, and download the file when the result looks right.

Configuration

Current draft

No draft saved yet

Recent downloads

No downloaded plinths yet.

Configuration name Name

Miniature scale reference

Imported at MiniCompare's 10 pixels = 1 mm scale.

View on MiniCompare

Find a mini on MiniCompare Search MiniCompare's public catalog, then choose the exact pose or view.

Images and scale data are provided by MiniCompare and may contain source-photo variation.

Plinth type Rectangular Circular

Measurement units Millimeters Inches Displayed dimensions convert between units, but generated geometry stays in millimeters.

Shared dimensions Base height Measured upward from the bottom plane at z = 0. Top slope angle Degrees applied to the top surface.

Rectangular base Depth World X span from the front edge to the back edge. Width World Y span from 0 to -width.

Circular base Diameter Measured straight across the circular footprint through its center.

Center feature No pole or hole Center pole Center hole

Pole height above base Measured above the top surface at the centered pole location. Pole diameter

Hole depth below top Measured below the top surface at the centered hole location. Hole diameter

Bottom holes Include bottom holes

Hole count Hole depth Hole diameter Hole inset Hole start angle

Decorative footer Include a stepped footer

Footer height Lower band outset Upper band outset Lower band height Footer fillet radius The footer adds a wider lower step and a narrower upper shoulder around the main plinth body.

Backdrop Include a backdrop

Backdrop height above base Backdrop depth The backdrop automatically spans the full rectangular plinth width and extends this far above the base top at the back edge.

Rectangular plinth preview

The viewer loads the same STL that the download link serves, with an optional correctly-scaled MiniCompare cutout.

Loading 3D preview...

Interactive STL preview; the cutout is centered on the mounting point at MiniCompare's 10 pixels per millimeter.

Search for a MiniCompare miniature in the configuration panel to add a scale reference.

Download STL

Current specification

Shape: Rectangular
Depth: 55 mm
Width: 55 mm
Height: 60 mm
Slope angle: 0°
Footer: Not included
Center feature: Not included
Bottom holes: 2 requested, 3 mm deep, 2 mm diameter, 5 mm inset, 90° start angle
Backdrop: Not included
MiniCompare reference: No mini selected